DJI Mini 3 / Mini 3 Pro drone repairs

We check the clips and the surround the cover mounts to, then fit a new cover matched to your model. Your DJI Mini 3 / Mini 3 Pro is checked to confirm the cover sits properly and does not touch the gimbal.

We open the battery, measure each cell and check the protection board. If the cells are above the safe threshold we bring them up slowly and wake the battery so it charges normally again. If a cell has dropped too low to be safe, we tell you, because that battery should not go back into service.

We inspect the airframe, motors, gimbal and sensors of your DJI Mini 3 / Mini 3 Pro, read the flight and error logs, and run the motors and gimbal on the bench. You get a clear list of what is damaged and what it takes to fix. Diagnosis is free when you go on to book a repair, so this paid check is for when you want the findings on their own.

We check for debris, a bent arm or a damaged ribbon cable, which are the usual causes of the gimbal failing its start-up sweep. The cause is corrected, the gimbal is recalibrated and your DJI Mini 3 / Mini 3 Pro is bench tested through several power cycles to confirm the error has gone.

We check the dampers, the gimbal arms, the motor bearings and the ribbon cable, and look for bent parts or debris. Worn dampers are replaced, bent arms are straightened or replaced and the gimbal is recalibrated. Your DJI Mini 3 / Mini 3 Pro is then bench tested with the camera recording to confirm the picture is steady.

We remove the damaged arm, route the new motor wiring through the replacement arm and connect it to the ESC board, then fit the arm and check the fold and lock. Your DJI Mini 3 / Mini 3 Pro is bench tested with all motors running and the drone is calibrated before it goes back.

We test the battery contacts, the power button and the power stages on the main board, then repair or replace the failed part with micro-soldering. Your DJI Mini 3 / Mini 3 Pro is powered up, checked for sensor status and bench tested with the motors and gimbal running.

We test each motor and its ESC channel to confirm which is at fault, then replace the failed components on the ESC board, or the board itself where the damage is extensive. Your DJI Mini 3 / Mini 3 Pro is bench tested with all motors running at matched speed before it goes back.

We remove the damaged assembly, check the ribbon cable and the connector on the main board, and fit a complete new gimbal and camera unit. It is calibrated and your DJI Mini 3 / Mini 3 Pro is bench tested with the camera recording before it goes back.